Intermediate Shaft Reassembly

Exploded View - R20A3 Engine Model

Exploded View - K24Z3 Engine Model
Special Tools Required

Oil seal driver, 64 mm
 07GAD-PH70201

Half shaft base
 07NAF-SR30101

Bearing driver attachment, 52 x 55 mm
 07746-0010400

Inner bearing driver attachment, 35 mm
  07746-0030400

Driver handle, 15 x 135L
 07749-0010000

Installer attachment, 45 mm
 07MAD-PR90100
NOTE:
  • Refer to the Exploded View, as needed, during this procedure.
  • The illustrations show K24Z3 engine model.
  1. Clean the disassembled parts with solvent, and dry them with compressed air.
    NOTE: Do not wash the rubber parts with solvent.
  1. Press a new intermediate shaft bearing (A) into the bearing support (B) using the 52 x 55 mm bearing driver attachment (C), the 15 x 135L driver handle (D), the half shaft base (E), and a press.