Driveshaft Reassembly
Adjust the length (A) of the driveshafts to the figure as shown, then adjust the boots to halfway between full compression and full extension. Bleed excess air from the boots by inserting a flat-tipped screwdriver between the boot and the joint.
Model
Left/Right Driveshaft
Specified Length (A)
R20A3 engine model
M/T
Left
559−564 mm (22.01−22.20 in.)
Right
547−552 mm (21.54−21.73 in.)
A/T
Left
557−562 mm (21.93−22.13 in.)
Right
545−550 m (21.46−21.65 in.)
K24Z3 engine model
M/T
Left
559−564 mm (22.01−22.20 in.)
Right
481−486 mm (18.94−19.13 in.)
A/T
Left
554−559 mm (21.81−22.01 in.)
Right
480−485 mm (18.90−19.09 in.)
Install new boot bands.
For the double loop type, go to
Step 11
.
For the low profile type, go to
Step 20
.
Left driveshaft
Right driveshaft