Driveshaft Disassembly
Special Tools Required

Threaded adapter, 26 x 1.5 mm
 07XAC-0010300

Sliding hammer set
 07936-5790002
Puller, commercially available
Boot band pliers, commercially available
Inboard Joint Side
  1. Remove the boot bands. Be careful not to damage the boot.
    • If the boot band is a welded type (A), cut the boot band.
    • If the boot band is a double loop type (B), lift up the band end (C), and push it into the clip (D).
    • If the boot band is a low profile type (E), pinch the boot band using commercially available boot band pliers (F).

Welded type
Double loop type
Low profile type