Raise the rear of the vehicle, and support it with safety stands in the proper locations.

Remove the rear wheels.

Remove the brake pads: Rear disc brake type, rear drum in disc brake type.

Using a micrometer, measure the brake disc or the brake disc/drum thickness at eight points, about 45 ° apart and 10 mm (0.39 in.) in from the outer edge of the brake disc or brake disc/drum. Replace the brake disc or the brake disc/drum if the smallest measurement is less than the max. refinishing limit.

Brake disc or the brake disc/drum thickness:
	Standard:			8.9−9.1 mm (0.35−0.36 in.)
	Max. refinishing limit:			8.0 mm (0.31 in.)
Brake disc or the brake disc/drum parallelism:
	0.015 mm (0.0006 in.) max.

NOTE: This is the maximum allowable difference between the thickness measurements.

If the brake disc or the brake disc/drum is beyond the service limit for parallelism, refinish the brake disc or the brake disc/drum with a commercially available on-car brake lathe.

NOTE: If the brake disc or the brake disc/drum is beyond the service limit for refinishing, replace it.

Clean the mating surfaces of the brake disc or the brake disc/drum and the inside of the wheel, then install the rear wheels.