Rear Brake Disc Replacement
  1. Remove the brake disc flat screws (A).
  1. Remove the brake disc/drum (B) from the hub bearing unit.
    NOTE:
    • Remove the access plug (C), then if necessary, turn the adjuster nut (D) with a flat-tip screwdriver until the shoes become loose.
    • If the brake disc/drum is stuck to the hub bearing unit, thread two 8 x 1.25 mm bolts (E) into the brake disc/drum to push it away from the hub bearing unit. Turn each bolt 90 degrees at a time to prevent the brake disc/drum from binding.
  1. Install the brake disc/drum in the reverse order of removal, and note these items:
    • Adjust the parking brake.
    • Before installing the brake disc/drum, clean the mating surfaces of the hub bearing unit and the inside of the brake disc/drum.
  1. Clean the mating surfaces of the brake disc/drum and the inside of the wheel, then install the rear wheel.