Front Lower Arm Removal/Installation
  1. Remove the lower arm mounting bolts, and remove the lower arm (A).
    NOTE: Use new lower arm mounting bolts during reassembly.
  1. Install the lower arm in the reverse order of removal, and note these items:
    • First install all the components, and lightly tighten the bolts and the nuts, then raise the suspension to load it with the vehicle's weight before fully tightening it to the specified torque values. Do not place the jack against the ball joint pin of the knuckle.
    • Be careful not to damage the ball joint boot when connecting the knuckle.
    • Before connecting the ball joint, degrease the threaded section and the tapered portion of the ball joint pin, and the ball joint connecting hole, and the threaded section and the mating surfaces of the castle nut.
    • Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align the castle nut by loosening it.
    • Before installing the wheel, clean the mating surfaces of the brake disc and the inside of the wheel.
  1. Check the wheel alignment, and adjust it if necessary.
  1. With HID lamp model: If the left side lower arm was removed, do the headlight initial position learning procedure.