Front Knuckle Ball Joint Replacement

Special Tools Required

C-frame
 070AF-S5A0310

Air hammer attachment
 070AF-TA00310

Attachment, 53 x 50 mm
 070AF-TA00320

Ball joint base attachment, 62 x 50 mm DP77
 070AF-TA00330

Ball joint remover, 28 mm
 07MAC-SL00201
NOTE:
  • When use the air hammer, confirms that the tank of the air compressor filled with air and gauge of the tank shows more than 440 kPa (4.5 kgf/cm 2 , 64 psi).
  • Replace the knuckle as an assembly if the knuckle ball joint has the paint mark (A). Paint mark indicate the ball joint has been replaced.