Wheel Alignment
Rear Toe Inspection/Adjustment
  1. Release the parking brake to avoid and incorrect measurement.
  1. Check the toe.
    Rear toe-in:
    2±2 mm (0.08±0.08 in.)

    • If adjustment is required, go to Step 3 .
    • If no adjustment is required, measure the turning angle.
  1. Hold the adjusting bolt (A) on the rear control arm (B), and loosen the self-locking nut (C).
  1. Replace the self-locking nut with a new one, and lightly tighten it.
    NOTE: Always use a new self-locking nut whenever it has been tightened to the specified torque.
  1. Adjust the rear toe by turning the adjusting bolt until the toe is correct.
  1. Tighten the self-locking nut while holding the adjusting bolt to the specified torque valve.