Wheel Alignment
Rear Camber Inspection
  1. Raise the rear of the vehicle, and remove the wheel caps.
    NOTE: Push out the cap on the aluminum wheel from the inside after removing the wheel.
  1. Install the wheel alignment gauge attachment (A) and camber/caster gauge on the wheel hub.
  1. Read the camber angle on the gauge with the bubble at the center of the gauge.
    Rear camber angle:
    With 16 inch wheels: −0 ° 50 '±30 '
    With 17 inch wheels: −1 ° 00 '±30 '
    With 18 inch wheels: −1 ° 12 '±30 '
    (Maximum difference between the right and left side: 0 ° 30 ')

    • If the measurement is within specifications, measure the toe-in.
    • If the measurement is not within specifications, check for bent or damaged suspension components.