Wake-up and Sleep Function
The multiplex integrated control system has ‘‘wake-up'' and ‘‘sleep'' functions to decrease parasitic draw on the battery when the ignition switch is in LOCK (0) position.
-
In the sleep mode, the multiplex integrated control system stops functioning (communication and CPU control) when it is not necessary for the system to operate.
-
As soon as any operation is requested (for example, a door is unlocked), the related control units in the sleep mode immediately wake up and begin to function.
-
When the ignition switch is turned to LOCK (0), and the driver's door is opened, then closed, there is a delay about 40 seconds before the control unit goes from the wake-up mode to the sleep mode.
-
The sleep mode will not function if any door is opened and a key is in the ignition.
-
The draw is reduced from 200 mA to less than 35 mA when in the sleep mode.