Fuel Line/Quick-Connect Fitting Precautions
The fuel line/quick-connect fittings (A), (B), and (C) connect the fuel rail (D) to the fuel feed hose (E), the fuel feed hose to the fuel line (F), the fuel line (G) to the fuel tank unit (H). When removing or installing the fuel feed hose, the fuel tank unit, or the fuel tank, it is necessary to disconnect or connect the quick-connect fittings.
Pay attention to the following:
  • The fuel feed hoses, fuel line, and quick-connect fittings are not heat-resistant; be careful not to damage them during welding or other heat-generating procedures.
  • The fuel feed hoses, fuel line, and quick-connect fittings are not acid-proof; do not touch them with a shop towel that was used for wiping battery electrolyte. Replace them if they come into contact with electrolyte or something similar.
  • When connecting or disconnecting the fuel feed hoses, fuel line, and quick-connect fittings, be careful not to bend or twist them excessively. Replace them if they are damaged.
A disconnected quick-connect fitting can be reconnected, but the retainer on the mating pipe cannot be reused once it has been removed from the pipe. Replace the retainer when:
  • replacing the fuel rail.
  • replacing the fuel line.
  • replacing the fuel pump.
  • replacing the fuel filter.
  • replacing the fuel tank.
  • it has been removed from the pipe.
  • it is damaged.
Use the same manufacturer retainer and the same size retainer when the replacing the retainer.
Location
Manufacturer
Retainer color
Piping diameter
A
Tokai DTR
Blue green
8 mm (0.3 in.)
B
Tokai DTR
Green
6.3 mm (0.2 in.)
C
Sanoh
White
9.5 mm (0.4 in.)