NOTE: This section explains the procedures after removal of all accessories and related parts. For accessories' and related parts' removal procedure, refer to the appropriate Shop Manual.

• Welding symbols
  : 2-Plate spot welding/ : 3-Plate spot welding/ : 4-Plate spot welding/ : MIG plug welding/ : MIG welding L= Welding length Unit: mm (in.)
• ( ): The number of welds

• If there is any damage to the center pillar, cut the (A) position and pry off the outer panel, and replace it.
  NOTE: Select the cutting positions in consideration of the front side outer panel repair part.
• Check the side sill reinforcement and center pillar stiffener position for damage.
• If necessary, cut the (B) position of the outer panel, and replace the center pillar stiffener.
• When replacing the side sill reinforcement, remove the front pillar lower stiffener, and carefully cut the (C) position at the side sill rear portion of the outer panel.
• Replace the front pillar outer and inner separators, and the center pillar outer and inner separators.