DTC Troubleshooting: 83
DTC 83:
 ECM/PCM Communication
  1. Turn the ignition switch to ON (II).
  1. Check for DTC with the HDS.
Is DTC 86 indicated?
YES -
Do the troubleshooting for DTC 86.■
NO -
Go to Step 3 .
  1. Clear the DTC with the HDS.
  1. Test-drive the vehicle.
    NOTE: Drive the vehicle on a straight section of road, not on a lift.
  1. Check for DTCs with the HDS.
Is DTC 83 indicated?
YES -
Go to Step 6 .
NO -
The system is OK at this time.■
  1. Check for fuel and emissions systems DTCs with the HDS:
Are any ECM/PCM DTCs indicated?
YES -
Do the applicable troubleshooting for the ECM/PCM.■
NO -
Go to Step 7 .
  1. Test-drive the vehicle.
    NOTE: Drive the vehicle on a straight section of road, not on a lift.
  1. Check for DTCs with the HDS.
Is DTC 83 indicated?
YES -
Check for loose terminals in the VSA modulator-control unit 47P connector. If the VSA modulator-control unit was updated, substitute a known-good VSA modulator-control unit, then retest. If the VSA modulator-control unit was substituted, go to Step 1 .
NO -
If the VSA modulator-control unit was updated, troubleshooting is complete. If the VSA modulator-control unit was substituted, replace the original VSA modulator-control unit. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.■