DTC Troubleshooting: 26-8x
DTC 26-8x (‘‘x'' can be 0 thru 9 or A thru F):
Short to Power in the Right Side Seat Belt Outer Lap Tensioner (RHD model)
NOTE:
  1. Turn the ignition switch to ON (II), then wait for 10 seconds.
Is DTC 26-8x indicated?
YES -
Go to Step 4 .
NO -
Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II), then wait for 10 seconds.
  1. Measure the voltage between the No. 4 and the No. 5 terminals of SRS unit connector B (39P) and body ground. There should be less than 0.5 V.
Is the voltage as specified?
YES -
Faulty SRS unit; replace the SRS unit. ■
NO -
Go to Step 11 .
  1. Turn the ignition switch to LOCK (0).
  1. Turn the ignition switch to ON (II), then wait for 10 seconds.
  1. Measure the voltage between the No. 4 and the No. 5 terminals of SRS unit connector B (39P) and body ground. There should be less then 0.5 V.
Is the voltage as specified?
YES -
Faulty right side seat belt outer lap tensioner; replace the right side seat belt outer lap tensioner. ■
NO -
Short to power in the SRS floor wire harness; replace the SRS floor wire harness.■