DTC Troubleshooting: 32-08, 32-09
DTC 32-08:
 Current Sensor (Regular Diagnosis)
DTC 32-09:
 Current Sensor (Initial Diagnosis)
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Turn the ignition switch to LOCK (0).
  1. Start the engine.
  1. Turn the steering wheel to the right or left, and wait 10 seconds or more.
  1. Check for DTCs with the HDS.
Is DTC 32-08 or 32-09 indicated?
YES -
Go to Step 7 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the EPS motor and the EPS control unit.■
  1. Turn the ignition switch to LOCK (0).
  1. Disconnect the EPS control unit connector B (2P) and connector C (2P).
  1. Check for continuity between following terminals of EPS control unit connector B (2P) and connector C (2P).
Is there continuity?
YES -
Check for loose terminals in the EPS control unit connectors and EPS motor connectors, and repair if necessary. If no poor connections are found, replace the EPS control unit. ■
NO -
Go to Step 10 .
  1. Disconnect the EPS motor 3P connector.
  1. On the EPS motor side, check for continuity between EPS motor 3P connector terminals No. 1 and No. 2, No. 1 and No. 3, No. 2 and No. 3 individually.
Is there continuity?
YES -
Repair open in the wire between the EPS control unit and the EPS motor.■
NO -
Replace the steering gearbox. The fault is an open in the EPS motor wire, or EPS motor internal circuit.■