Keyless/Power Door Locks/Security System Symptom Troubleshooting Information

Power Door Locks/Keyless
  1. Check for B-CAN DTCs. If any B-CAN DTCs are indicated, troubleshoot and resolve them first.
  1. If the door lock system and the keyless operation do not work, troubleshoot the door locks first.
    NOTE: The system does not function when the ignition switch is ON (II).
    No.
    Symptom
    Check Items
    1
    All the doors will not lock or unlock. *1
    • Poor ground (G501, G502, G505, G601, G651)
    • Door switch test (check the door switch ON/OFF information with the HDS)
    • Door lock switch test (check the door switch ON/OFF information with the HDS)
    • Also, check for continuity of the UART line between the door multiplex control unit 37P connector No. 27 terminal and the front passenger's power window switch 37P connector No. 29 terminal
    2
    Driver's, left rear doors and fuel fill door lock actuator will not lock or unlock.
    3
    Front passenger's and right rear doors will not lock or unlock.
    4
    Keyless operation does not work (LOCK, UNLOCK).
    5
    Doors will not unlock with the transmitter, but will unlock with the door lock switch and the door key cylinder switch.
    6
    Doors will not lock with the transmitter, but will lock with the door lock switch and the door key cylinder switch.
    7
    Doors automatically relock 30 seconds after being unlocked with the transmitter even though a door has been opened.
    8
    Only driver's door will unlock or door locks relock immediately after unlocking with the remote.
    9
    Keyless operation will work even though the ignition key is in the ignition switch.

    *1:
    If only one door is not working properly, check that door's lock actuator first, then check the other items listed in this table.
    *2:
    With ACC
    *3:
    Without ACC