Sunroof Glass Position Adjustment
The roof panel (A) should be even with the glass weatherstrip (B), to within 0+1/−1 mm (0+0.04/−0.04 in.) all the way around, and the weatherstrip should evenly touches the roof panel in its front and rear. If not, make the following adjustment:
  1. Remove the bracket cover.
  1. Adjust the glass (A).
    -1.
    Using a TORX T25 bit, slightly loosen the bolts.
    -2.
    Move the glass up or down and forward or rearward.
    -3.
    Tighten all bolts securely.
  1. If necessary, repeat on the opposite side.