Detach the clips (A) securing the sunroof subharness (B).
LHD model
RHD model
Put on gloves to protect your hands. Remove the screws (A), and remove the screws (B) securing the cable tube rear brackets (C). Remove the cable tube side bracket mounting bolts (D) and the cable tube mounting screws (E) from both sides of the frame (F).
Turn both cable tube side brackets (A) up to release the hooks (B) from the holes in both sides of the frame.
Pivot the glass brackets (C) down by sliding the link lifters (D) back, then slide both glass brackets back with the link lifters.
Slide the cable assembly (E) half-way.
Remove the drain channel sliders (A) from both sides.
Slide the cable assembly (A) and both glass brackets (B) back, remove the deflector sliders (C) from both glass brackets, then remove them from the frame (D).
Install the slider and cable assembly in the reverse order of removal, and note these items:
Damaged parts should be replaced.
Apply multipurpose grease to the glass bracket (A) and the guide rail portion of the frame (B) indicated by the arrows.
Before reinstalling the motor, make sure both link lifters are parallel, and in the tilt-up position.
