480 Turbo, 1.7i ,, ,1721 cc ,1988-91, Engine Code B18FT,

Ignition data

480 Turbo, 1.7i
Ignition system type: El-ecu
Ignition coil make/type: Bo/TZ61-2
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.72 Ohms
Secondary resistance: 7700 Ohms
Distributor make/type: n / a
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 8
3/800 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: n / a Deg eng/rpm (without vacuum)
Timing mark location: Flywheel
No 1 plug location: N/S/F
Firing Order: 1-3-4-2
Spark plug make: Bosch
Spark plug type: WR9DS
Electrode gap: 0.7-0.8 mm

Fuel System

480 Turbo, 1.7i
Fuel type: U Cat
Fuel pump type/pressure: Elec/3.5 bar
Engine idle speed: 800
50 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.6
0.2 Vol %

Engine Data

480 Turbo, 1.7i
Valve clearance - inlet: 0.20 c mm (cold)
Valve clearance - exhaust: 0.50 c mm (cold)
Compression pressure: 12-14 bar
Oil pressure: 3.5/3000 bar/eng/rpm
Radiator pressure cap: 1.5 bar/type
Drive belt 1 - size: PV/KKB113 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

480 Turbo, 1.7i
Alternator output: 59/3000 Amps/eng/rpm
Regulated output: 13.5-15.0 Volts
Battery: 12/55 V/Ah
Starter motor make/type: Lu/LRS436

Other data

480 Turbo, 1.7i
Clutch operation type: Cable
Clutch adjustment: 35-40 Above B.Ped mm
Cambelt failure: Damage
Cambelt Part Number: 3343720-3
Tyre pressures: 2.1(30)f 1.9(28)r bar (psi)

Component Locations
Fuel Filter: 10
Fuel Pump: 16
ECU-Fuel: 11
ECU-Ignition: 1
Fuel Pump Relay: 12
Fuel Injection Relay: 12
Ignition Power Relay: 12

Check location diagram