360 2.0, ,, 1990 cc, 1985-89, ,Engine Code B200K

Ignition data

360 2.0,
Ignition system type: El-h
Ignition coil make/type: Bo/0 221 122 334
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.4-0.8 Ohms
Secondary resistance: 2500-5500 Ohms
Distributor make/type: Bo/0 237 501 004
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: n / a Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 10
2/900 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: Champion
Spark plug type: N7YC
Electrode gap: 0.75 mm

Fuel System

360 2.0,
Fuel type: L
Fuel pump type/pressure: Mech/0.15-0.27 bar
Engine idle speed: 900 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 1.0-2.5 Vol %

Engine Data

360 2.0,
Valve clearance - inlet: 0.40-0.45 h mm (hot)
Valve clearance - exhaust: 0.40-0.45 h mm (hot)
Compression pressure: 9-11 bar
Oil pressure: 2.5-6/2000 bar/eng/rpm
Radiator pressure cap: 0.65-0.85 bar/type
Drive belt 1 - size: 9.5x925 KDB925 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

360 2.0,
Alternator output: 47/3000 Amps/eng/rpm
Regulated output: 13.5-14.1 Volts
Battery: 12/55 V/Ah
Starter motor make/type: Lu/LRS229

Other data

360 2.0,
Clutch operation type: Cable
Clutch adjustment: n / a mm
Cambelt failure: Damage
Cambelt Part Number: 463377-2
Tyre pressures: 1.8(26)f 2.1(30)r bar (psi)

Component Locations
Fuel Filter: 15
Fuel Pump: 7
ECU-Fuel: 6
ECU-Ignition: 15
Fuel Pump Relay: 3

Check location diagram