940 2.3i, ,, 2316 cc, 1990-, Engine Code B230FB,

Ignition data

940 2.3i,
Ignition system type: El-ecu
Ignition coil make/type: Bo/0 221 118 351
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.6-0.8 Ohms
Secondary resistance: 6900-8500 Ohms
Distributor make/type: Bo/0 237 502 002
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 12/775 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: n / a Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: Bosch
Spark plug type: WR7DC
Electrode gap: 0.7 mm

Fuel System

940 2.3i,
Fuel type: U Cat
Fuel pump type/pressure: Elec/3.0 bar
Engine idle speed: 775 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.4-0.8 Vol %

Engine Data

940 2.3i,
Valve clearance - inlet: 0.35-0.45 h mm (hot)
Valve clearance - exhaust: 0.35-0.45 h mm (hot)
Compression pressure: 9.0 bar
Oil pressure: 2.5-6.0/2000 bar/eng/rpm
Radiator pressure cap: 1.0 bar/type
Drive belt 1 - size: 9.5x999 KDB999 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

940 2.3i,
Alternator output: 31/1500 Amps/eng/rpm
Regulated output: 13.8-14.6 Volts
Battery: 12/50 V/Ah
Starter motor make/type: Bo/0 001 108 088

Other data

940 2.3i,
Clutch operation type: Cable
Clutch adjustment: S.Adj mm
Cambelt failure: Damage
Cambelt Part Number: 463377-2
Tyre pressures: 1.9(28)f 1.9(28)r [Est.=1.9(28)f 2.1(30)r] bar (psi)