240, ,, 1987 cc, 1991-, Engine Code B200F,

Ignition data

240,
Ignition system type: El-ecu
Ignition coil make/type: Bo/0 221 122 364
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.6-0.8 Ohms
Secondary resistance: 6900-8500 Ohms
Distributor make/type: Bo/0 237 502 002
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 12/750 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: n / a Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: Bosch
Spark plug type: WR7DC
Electrode gap: 0.7 mm

Fuel System

240,
Fuel type: U Cat
Fuel pump type/pressure: Elec/3.0 bar
Engine idle speed: 775 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.4-0.8 Vol %

Engine Data

240,
Valve clearance - inlet: 0.30-0.40 c mm (cold)
Valve clearance - exhaust: 0.30-0.40 c mm (cold)
Compression pressure: 9.0 bar
Oil pressure: 2.5-6.0/2000 bar/eng/rpm
Radiator pressure cap: 0.65-0.85 bar/type
Drive belt 1 - size: HC38x913 mm/type
Drive belt 2 - size: HC38x863 mm/type

Electrical System

240,
Alternator output: 64/1500 Amps/eng/rpm
Regulated output: 13.4-14.2 Volts
Battery: 12/60 V/Ah
Starter motor make/type: Bo/0 001 108 088

Other data

240,
Clutch operation type: Hyd
Clutch adjustment: S/Adj. mm
Cambelt failure: Damage
Cambelt Part Number: 271713-0
Tyre pressures: 2.1(30)f 1.9(27)r bar (psi)

Component Locations
Fuel Filter: 10/1
Fuel Pump: 10
ECU-Fuel: 11/15
ECU-Ignition: 3
Fuel Pump Relay: 4
Fuel Injection Relay: 4

Check location diagram