240 GL/GLT, 2.0i/2.3i ,, 1990/2320 cc, 1985-92, Engine Code B200/230E,

Ignition data

240 GL/GLT, 2.0i/2.3i
Ignition system type: El-i
Ignition coil make/type: Bo/0 221 122 334
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.6-0.8 Ohms
Secondary resistance: 6900-8500 Ohms
Distributor make/type: Bo/0 237 024 015
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: n / a Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 10/750 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: Bosch
Spark plug type: W6DC
Electrode gap: 0.75 mm

Fuel System

240 GL/GLT, 2.0i/2.3i
Fuel type: L
Fuel pump type/pressure: Elec/3.4-3.8 bar
Engine idle speed: 900 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.5-2.0 Vol %

Engine Data

240 GL/GLT, 2.0i/2.3i
Valve clearance - inlet: 0.40 h mm (hot)
Valve clearance - exhaust: 0.40 h mm (hot)
Compression pressure: 9-11 bar
Oil pressure: 2.5-6 bar/eng/rpm
Radiator pressure cap: 0.65-0.85 bar/type
Drive belt 1 - size: 9.5x925 KDB925 mm/type
Drive belt 2 - size: 9.5x938 KDB938 mm/type

Electrical System

240 GL/GLT, 2.0i/2.3i
Alternator output: 64/4000 Amps/eng/rpm
Regulated output: 13.8-14.3 Volts
Battery: 12/70 V/Ah
Starter motor make/type: Hit/S114-232

Other data

240 GL/GLT, 2.0i/2.3i
Clutch operation type: Hyd
Clutch adjustment: S/Adj. mm
Cambelt failure: Damage
Cambelt Part Number: 463377-2
Tyre pressures: 1.8(26)f 2.1(30)r [Est.=1.9(28)f 2.1(30)r] bar (psi)

Component Locations
Fuel Filter: 10/1
Fuel Pump: 10
ECU-Fuel: 11/15
ECU-Ignition: 3
Fuel Pump Relay: 4
Fuel Injection Relay: 4

Check location diagram