Senator-B, 2.6i ,, 2594 cc, 1990-93, Engine Code C26NE,

Ignition data

Senator-B, 2.6i
Ignition system type: Map-i
Ignition coil make/type: Bo/0 221 122 408
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.65-0.79 Ohms
Secondary resistance: 6800-7800 Ohms
Distributor make/type: Bo/0 237 505 201
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: n / a Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 6-12/670 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-5-3-6-2-4
Spark plug make: n / a
Spark plug type: n / a
Electrode gap: 0.75 mm

Fuel System

Senator-B, 2.6i
Fuel type: U Cat
Fuel pump type/pressure: Elec/2.5 bar
Engine idle speed: 670-830 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.4 Max Vol %

Engine Data

Senator-B, 2.6i
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: n / a bar
Oil pressure: 1.0/830 bar/eng/rpm
Radiator pressure cap: 1.2-1.5 bar/type
Drive belt 1 - size: 6K 1460 mm/type
Drive belt 2 - size: 6K 2230 mm/type

Electrical System

Senator-B, 2.6i
Alternator output: 90/6000 Amps/eng/rpm
Regulated output: 13.7-14.5 Volts
Battery: 12/66 V/Ah
Starter motor make/type: Bo/0 001 108 080

Other data

Senator-B, 2.6i
Clutch operation type: Cable
Clutch adjustment: 155/P.Travel mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 2.2(31)f 2.2(31)r bar (psi)