Senator/Monza, 2.5i ,, 2490 cc, 1985-87, Engine Code 25E,

Ignition data

Senator/Monza, 2.5i
Ignition system type: El-h
Ignition coil make/type: Bo/1 227 020 009
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.6-0.9 Ohms
Secondary resistance: 6300-9300 Ohms
Distributor make/type: Bo/0 237 503 001
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 7/800 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 10/800 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-5-3-6-2-4
Spark plug make: Bosch
Spark plug type: WR7BC
Electrode gap: 0.7-0.8 mm

Fuel System

Senator/Monza, 2.5i
Fuel type: L/U
Fuel pump type/pressure: Elec/2.5 bar
Engine idle speed: 800
25 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.5 Max Vol %

Engine Data

Senator/Monza, 2.5i
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: 11-12.5 bar
Oil pressure: 1/825 bar/eng/rpm
Radiator pressure cap: 1.0-1.15 bar/type
Drive belt 1 - size: 9.5x888 KDB888 mm/type
Drive belt 2 - size: 9.5x875 KDB875 mm/type

Electrical System

Senator/Monza, 2.5i
Alternator output: 75/2500 Amps/eng/rpm
Regulated output: 13.7-14.5 Volts
Battery: 12/66 V/Ah
Starter motor make/type: Lu/LRS871

Other data

Senator/Monza, 2.5i
Clutch operation type: Cable
Clutch adjustment: 155/P.Travel mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 2.2(31)f 2.2(31)r bar (psi)