SC100 SX/GX, Cervo ,, 970 cc, 1979-87, Engine Code n / a,

Ignition data

SC100 SX/GX, Cervo
Ignition system type: CB
Ignition coil make/type: Mit/-
Supply voltage: n / a
Primary resistance: 1.5 Ohms
Secondary resistance: 8000 Ohms
Distributor make/type: Mit/-
Contact breaker gap/air: 0.4-0.5 mm
Dwell angle: 52 Deg
Ignition Timing - unleaded: 10/800 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 10/800 Deg eng/rpm (without vacuum)
Timing mark location: Flywheel
No 1 plug location: O/S/F
Firing Order: 1-3-2
Spark plug make: NGK
Spark plug type: BPR5ES
Electrode gap: 0.7-0.8 mm

Fuel System

SC100 SX/GX, Cervo
Fuel type: L/U
Fuel pump type/pressure: Mech/0.25-0.35 bar
Engine idle speed: 800
50 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 1.5
0.5 Vol %

Engine Data

SC100 SX/GX, Cervo
Valve clearance - inlet: 0.13-0.18 c mm (cold)
Valve clearance - exhaust: 0.13-0.18 c mm (cold)
Compression pressure: 14.0 bar
Oil pressure: 3-4.5/3000 bar/eng/rpm
Radiator pressure cap: 0.9 bar/type
Drive belt 1 - size: 9.5x750 KDB750 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

SC100 SX/GX, Cervo
Alternator output: 40/3000 Amps/eng/rpm
Regulated output: 13.8-14.8 Volts
Battery: 12/35 V/Ah
Starter motor make/type: Mit/-

Other data

SC100 SX/GX, Cervo
Clutch operation type: Cable
Clutch adjustment: 15-25/Pedal mm
Cambelt failure: Damage
Cambelt Part Number: 12761-73000
Tyre pressures: 1.4(20)f 2.2(31)r bar (psi)