SJ410/V/K, Jeep ,, 970 cc, 1982-91, Engine Code F10A,

Ignition data

SJ410/V/K, Jeep
Ignition system type: CB
Ignition coil make/type: Mit/-
Supply voltage: n / a
Primary resistance: 1.5 Ohms
Secondary resistance: 10000 Ohms
Distributor make/type: Mit/-
Contact breaker gap/air: 0.4-0.5 mm
Dwell angle: 52 Deg
Ignition Timing - unleaded: 10/850 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 10/850 Deg eng/rpm (without vacuum)
Timing mark location: Flywheel
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: NGK
Spark plug type: BPR5ES
Electrode gap: 0.7-0.8 mm

Fuel System

SJ410/V/K, Jeep
Fuel type: L/U
Fuel pump type/pressure: Mech/0.25-0.35 bar
Engine idle speed: 800 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 1.5
0.5 Vol %

Engine Data

SJ410/V/K, Jeep
Valve clearance - inlet: 0.13-0.18 c mm (cold)
Valve clearance - exhaust: 0.13-0.18 c mm (cold)
Compression pressure: 12-13.5 bar
Oil pressure: 3-4.5/3000 bar/eng/rpm
Radiator pressure cap: 0.9 bar/type
Drive belt 1 - size: 9.5x750 KDB750 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

SJ410/V/K, Jeep
Alternator output: 35/3000 Amps/eng/rpm
Regulated output: 3.8-14.8 Volts
Battery: 12/30 V/Ah
Starter motor make/type: Mit/-

Other data

SJ410/V/K, Jeep
Clutch operation type: Cable
Clutch adjustment: 15-25/Pedal mm
Cambelt failure: Damage
Cambelt Part Number: n / a
Tyre pressures: 1.4(20f 1.4(20)r bar (psi)