Rover, 827i ,, 2675 cc, 1991, Engine Code V6-2.7,

Ignition data

Rover, 827i
Ignition system type: El-ecu
Ignition coil make/type: Den/TC-09A
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.71-0.81 Ohms
Secondary resistance: n / a Ohms
Distributor make/type: Den/TD-01T
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 15
2/680 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 15
2/720 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: O/S/R
Firing Order: 1-4-2-5-3-6
Spark plug make: Champion
Spark plug type: XHM279
Electrode gap: 1.0 mm

Fuel System

Rover, 827i
Fuel type: L/U +Cat
Fuel pump type/pressure: Elec/4.1 bar
Engine idle speed: 720
50 [Cat=680] rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.5
0.25 [Cat=0.1Max] Vol %

Engine Data

Rover, 827i
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: n / a bar
Oil pressure: n / a bar/eng/rpm
Radiator pressure cap: 1.0 bar/type
Drive belt 1 - size: PV/1088 KHB108 mm/type
Drive belt 2 - size: PV/913 KIB913 mm/type

Electrical System

Rover, 827i
Alternator output: 70/5500 Amps/eng/rpm
Regulated output: 13.6-14.4 Volts
Battery: 12/63 V/Ah
Starter motor make/type: Bo/0 001 108 076

Other data

Rover, 827i
Clutch operation type: Hyd
Clutch adjustment: 1-7/Pedal mm
Cambelt failure: Damage
Cambelt Part Number: GTB108
Tyre pressures: 1.8(28)f 1.8(26)r bar (psi)