Rover 825i, Sterling ,, 2494 cc, 1986-88, Engine Code V6-2.5,

Ignition data

Rover 825i, Sterling
Ignition system type: El-ecu
Ignition coil make/type: Den/TC04C
Supply voltage: n / a
Primary resistance: 0.35-0.43 Ohms
Secondary resistance: 9040-13560 Ohms
Distributor make/type: Den/TD05R
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 3/770 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 13
2/770 [AT=7/770] Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: O/S/R
Firing Order: 1-4-2-5-3-6
Spark plug make: Champion
Spark plug type: RC9YC
Electrode gap: 1.0 mm

Fuel System

Rover 825i, Sterling
Fuel type: L/U
Fuel pump type/pressure: Elec/4.1 bar
Engine idle speed: 770
50 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.25-0.75 Vol %

Engine Data

Rover 825i, Sterling
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: 10.3 Min bar
Oil pressure: n / a bar/eng/rpm
Radiator pressure cap: 1.0 bar/type
Drive belt 1 - size: PV/1088 KHB108 mm/type
Drive belt 2 - size: PV/913 KIB913 mm/type

Electrical System

Rover 825i, Sterling
Alternator output: 70/5500 Amps/eng/rpm
Regulated output: 14-15 Volts
Battery: 12/63 V/Ah
Starter motor make/type: Del/DR5U1

Other data

Rover 825i, Sterling
Clutch operation type: Hyd
Clutch adjustment: 1-7/Pedal mm
Cambelt failure: Damage
Cambelt Part Number: GTB1208
Tyre pressures: 2.0(28)f 2.0(28)r bar (psi)