Metro, 1.1 ,, 1120 cc, 1990-, ,Engine Code K8-1.1

Ignition data

Metro, 1.1
Ignition system type: El-i
Ignition coil make/type: Lu/AUU/ADU
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.71-0.81 Ohms
Secondary resistance: n / a Ohms
Distributor make/type: Lu/NJC 10024
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 8
1/1500 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 8
1/1500 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: O/S/F
Firing Order: 1-3-4-2
Spark plug make: Unipart
Spark plug type: GSP6662
Electrode gap: 0.85 mm

Fuel System

Metro, 1.1
Fuel type: L/U +Cat
Fuel pump type/pressure: n / a bar
Engine idle speed: 850
50 rpm
Fast idle speed: 1200 rpm
CO level at idle speed: 2.0-3.0 Vol %

Engine Data

Metro, 1.1
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: n / a bar
Oil pressure: 4.1 bar/eng/rpm
Radiator pressure cap: 0.9-1.0 bar/type
Drive belt 1 - size: PV/KIB 775 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

Metro, 1.1
Alternator output: 65/3000 Amps/eng/rpm
Regulated output: 13.9-14.3 Volts
Battery: 12/35 V/Ah
Starter motor make/type: Bo/0 001 108 080

Other data

Metro, 1.1
Clutch operation type: Cable
Clutch adjustment: S/Adj. mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 2.1(30)f 2.1(30)r bar (psi)