Metro 1.3, Metro Van ,, 1275 cc, 1980-90, Engine Code 12H,

Ignition data

Metro 1.3, Metro Van
Ignition system type: CB
Ignition coil make/type: Lu/DLB102
Supply voltage: 4.5 + Volts with ballast resistor
Primary resistance: 1.2-1.5 Ohms
Secondary resistance: n / a Ohms
Distributor make/type: Lu/41858
Contact breaker gap/air: 0.4 mm
Dwell angle: 49-59 Deg
Ignition Timing - unleaded: n / a Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 13/1500 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: N/S/F
Firing Order: 1-3-4-2
Spark plug make: Unipart
Spark plug type: GSP263 [86-=4362]
Electrode gap: 0.9 mm

Fuel System

Metro 1.3, Metro Van
Fuel type: L
Fuel pump type/pressure: Mech/0.4 bar
Engine idle speed: 650 rpm
Fast idle speed: 1100 rpm
CO level at idle speed: 1.5-3.5 Vol %

Engine Data

Metro 1.3, Metro Van
Valve clearance - inlet: 0.30 c mm (cold)
Valve clearance - exhaust: 0.30 c mm (cold)
Compression pressure: n / a bar
Oil pressure: 4.2/3000 bar/eng/rpm
Radiator pressure cap: 1.05 KRB250 bar/type
Drive belt 1 - size: 9.5x825 KDB825 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

Metro 1.3, Metro Van
Alternator output: 45/3000 Amps/eng/rpm
Regulated output: 13.6-14.4 Volts
Battery: 12/42 V/Ah
Starter motor make/type: Lu/LRS343

Other data

Metro 1.3, Metro Van
Clutch operation type: Hyd
Clutch adjustment: 1/Lever mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 2.0(28)f 2.2(31)r [86-=1.8(26)r] bar (psi)