605, 3.0i ,, 2975 cc, 1989-, Engine Code ZPJ4 (SKZ),

Ignition data

605, 3.0i
Ignition system type: El-ecu
Ignition coil make/type: n / a
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.7 Ohms
Secondary resistance: 6600 Ohms
Distributor make/type: Fen/-
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: n / a Deg eng/rpm (without vacuum)
Ignition Timing - leaded: n / a Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Flywheel
Firing Order: 1-6-3-5-2-4
Spark plug make: Eyquem
Spark plug type: RFC58LS3
Electrode gap: 1.2 mm

Fuel System

605, 3.0i
Fuel type: U Cat
Fuel pump type/pressure: Elec/- bar
Engine idle speed: 800
50 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 2.0 Vol %

Engine Data

605, 3.0i
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: n / a bar
Oil pressure: 4.2/2500 bar/eng/rpm
Radiator pressure cap: 1.4 bar/type
Drive belt 1 - size: n / a mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

605, 3.0i
Alternator output: n / a Amps/eng/rpm
Regulated output: 13.8-14.8 Volts
Battery: 12/55 V/Ah
Starter motor make/type: Lu/M78R

Other data

605, 3.0i
Clutch operation type: Cable
Clutch adjustment: S/Adj. mm
Cambelt failure: Damage
Cambelt Part Number: n / a
Tyre pressures: 2.3(33)f 2.3(33)r bar (psi)