Cherry 1.0, (N10/N12) ,, 987 cc, 1981-86, , Engine Code E10

Ignition data

Cherry 1.0, (N10/N12)
Ignition system type: CB
Ignition coil make/type: Lu/DLB102
Supply voltage: 12 - Volts without ballast resistor
Primary resistance: 1.35-1.65 Ohms
Secondary resistance: 6800-10200 Ohms
Distributor make/type: Hit/D412-A9
Contact breaker gap/air: 0.45-0.55 mm
Dwell angle: 49-55 Deg
Ignition Timing - unleaded: 2
2/700 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 2
2/700 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: O/S/F
Firing Order: 1-3-4-2
Spark plug make: NGK
Spark plug type: BPR5ES
Electrode gap: 0.7 mm

Fuel System

Cherry 1.0, (N10/N12)
Fuel type: L/U
Fuel pump type/pressure: Mech/0.17-0.24 bar
Engine idle speed: 700
50 rpm
Fast idle speed: 1800
100 rpm
CO level at idle speed: 1.5
0.5 Vol %

Engine Data

Cherry 1.0, (N10/N12)
Valve clearance - inlet: 0.35 h mm (hot)
Valve clearance - exhaust: 0.35 h mm (hot)
Compression pressure: 10.0/12.7 bar
Oil pressure: 2/1000 bar/eng/rpm
Radiator pressure cap: 0.9 KRB240 bar/type
Drive belt 1 - size: 9.5x838 KDB838 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

Cherry 1.0, (N10/N12)
Alternator output: 40/2500 Amps/eng/rpm
Regulated output: 14.4-15.0 Volts
Battery: 12/45 V/Ah
Starter motor make/type: Lu/LRS249

Other data

Cherry 1.0, (N10/N12)
Clutch operation type: Hyd
Clutch adjustment: 11-21/Pedal mm
Cambelt failure: Damage
Cambelt Part Number: 1302850A100
Tyre pressures: 1.8(26)f 1.8(26)r bar (psi)