Cabstar, F22 ,, 1952 cc, 1982-93, Engine Code Z20,

Ignition data

Cabstar, F22
Ignition system type: CB
Ignition coil make/type: Hit/C6R-225
Supply voltage: 12 - Volts without ballast resistor
Primary resistance: 1.35-1.65 Ohms
Secondary resistance: 7500-11300 Ohms
Distributor make/type: Hit/D409-83/82
Contact breaker gap/air: 0.5 mm
Dwell angle: 49-55 Deg
Ignition Timing - unleaded: 4
1/650 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 4
1/650 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-3-4-2
Spark plug make: NGK
Spark plug type: BPR6ES
Electrode gap: 0.8 mm

Fuel System

Cabstar, F22
Fuel type: L/U
Fuel pump type/pressure: Mech/0.21-0.27 bar
Engine idle speed: 650
50 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 1.0
0.5 Vol %

Engine Data

Cabstar, F22
Valve clearance - inlet: 0.30 h mm (hot)
Valve clearance - exhaust: 0.30 h mm (hot)
Compression pressure: 8.8-11.8 bar
Oil pressure: n / a bar/eng/rpm
Radiator pressure cap: 0.88 bar/type
Drive belt 1 - size: 9.5x888 KDB888 mm/type
Drive belt 2 - size: n / a mm/type

Electrical System

Cabstar, F22
Alternator output: 40/2500 Amps/eng/rpm
Regulated output: 13.8-14.8 Volts
Battery: 12/60 V/Ah
Starter motor make/type: Lu/LRS396

Other data

Cabstar, F22
Clutch operation type: Hyd
Clutch adjustment: 1-5/Pedal mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 3.5(50)f 5.2(74)r bar (psi)