Laurel 2.4i, (C32) ,, 2393 cc, ,1986-89 , Engine Code L24E

Ignition data

Laurel 2.4i, (C32)
Ignition system type: El-I
Ignition coil make/type: Han/STC-30
Supply voltage: 11.5 - Volts without ballast resistor
Primary resistance: 0.83-1.03 Ohms
Secondary resistance: 8400-12800 Ohms
Distributor make/type: Hit/D6K84-02
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 10
2/700 +vac Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 10
2/700 +vac Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-5-3-6-2-4
Spark plug make: NGK
Spark plug type: BPR6ES-11
Electrode gap: 1.05 mm

Fuel System

Laurel 2.4i, (C32)
Fuel type: L/U
Fuel pump type/pressure: Elec/4.3-4.9 bar
Engine idle speed: 700
50 [AT=740
50/N] rpm
Fast idle speed: n / a rpm
CO level at idle speed: 0.4 Vol %

Engine Data

Laurel 2.4i, (C32)
Valve clearance - inlet: 0.30 h mm (hot)
Valve clearance - exhaust: 0.30 h mm (hot)
Compression pressure: 8.8-11.8 bar
Oil pressure: 2.9/2000 bar/eng/rpm
Radiator pressure cap: 0.8-1.0 bar/type
Drive belt 1 - size: 12.5x875 KEB875 mm/type
Drive belt 2 - size: 12.5x1125 KEB112 mm/type

Electrical System

Laurel 2.4i, (C32)
Alternator output: 60/3000 Amps/eng/rpm
Regulated output: 14.4-14.7 Volts
Battery: 12/60 V/Ah
Starter motor make/type: Lu/LRS227

Other data

Laurel 2.4i, (C32)
Clutch operation type: Hyd
Clutch adjustment: 1-3/Pedal mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 1.8(26)f 1. 8(26)r bar (psi)