190E 2.6, (201), 2599 cc, 1986-, Engine Code 103.942,

Ignition data

190E 2.6, (201)
Ignition system type: El-ecu
Ignition coil make/type: Bo/0 221 501 007
Supply voltage: 12 - Volts without ballast resistor
Primary resistance: 0.3-0.6 Ohms
Secondary resistance: 8000-13000 Ohms
Distributor make/type: Bo/0 237 500 004
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 7-11/700 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: 7-11/700 Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-5-3-6-2-4
Spark plug make: Bosch
Spark plug type: H8DC
Electrode gap: 0.8 mm

Fuel System

190E 2.6, (201)
Fuel type: L/U +Cat
Fuel pump type/pressure: Elec/5.3-5.5 bar
Engine idle speed: 650-750 rpm
Fast idle speed: n / a rpm
CO level at idle speed: n / a Vol %

Engine Data

190E 2.6, (201)
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: 8.15-12 bar
Oil pressure: 3.0/3000 bar/eng/rpm
Radiator pressure cap: 1.1-1.2 bar/type
Drive belt 1 - size: PV/KKB225 mm/type
Drive belt 2 - size: PV/KKB217 mm/type

Electrical System

190E 2.6, (201)
Alternator output: 70/2230 Amps/eng/rpm
Regulated output: 13.7-14.5 Volts
Battery: 12/62 V/Ah
Starter motor make/type: Lu/LRS655

Other data

190E 2.6, (201)
Clutch operation type: Hyd
Clutch adjustment: 150/P.Travel mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 2.0(28)f 2.2(31)r bar (psi)